nickel bronze castingure and cut the leather straps and lace them through the slits.1 Comb the hair to remove all tangles and to smooth it out com pletely. If you are braiding only a portion of the head, gather the hair that you will braid, and tie off the rest to keep it out of the way. 2 Spray the hair with a light mist of water or add hair gel to keep the hair smooth and to make it more mana geable. 3 Separate the hair into three equal sections at the top of the head or wherever you want to begin your braid. 4 Pass 3 day military diet the left section of hair over the center section. The left section is now the center section. Repeat with the section on the right side. 5 Gather a small section of hair from the left side, and add it to the section of hair on the left. Perform this nickel bronze casting work as closely as possible to the braid to give a tighter appearance. 6 Cross the left section over the center and lay it a . ssing it over the center section, laying it as high as possible on the braid and making it snug. Ensure that the sections of hair you are adding remain a consistent size to improve the smoothness and tightness of the completed braid. 9 Continue braid ing with gentle but consistent tension until you have reached the nape of the neck and there is no more hair to add into the braid. Secure hair with an elastic band or continue to braid down the back until you reach your preferred end point. Secure w free move icon ith an elastic band wrapped as closely as possible to the end of the braid.1 Push the ends of your shoelace through the botto m eyelets of your Skytops. Adjust the lace so you have equal amounts on either side of the shoe. Make sure the lace is flat a nickel bronze casting cross the tongue of the shoe, not twisted. 2 Pull the right lace end to the left side of the shoe and come up through the bot . ainst the shoe tongue and not twisted. 3 Continue lacing the Skytop shoe, drawing the shoelace up from below the eyelets to o ut the top of the shoe. Make sure the lace is flat after each row. Stop when you reach the spot on your shoe with two holes s ide by side. 4 Pull your lace from below through the hole closest to the tongue of the shoe and thread the lace back down thr ough the hole right beside it, creating a dash mark with your shoe lace. Do this on both sides of the Skytop shoe. Note the l photoshop textures newspaper aces do not cross over the tongue during this step and the laces are inside the shoe after this step. 5 Thread the lace ends up through the top hole farthest away from the tongue. Pull about two inches of lace through the hole and allow it to hang. T nickel bronze casting uck the excess lace into the shoe. Do this on both sides. Note the eyelets between the dash mark and the top eyelet are not u .
|
|