diy casting bronze statuesctivities within four weeks.1 Insert one of the laces into the bottom shoelace eyelet of your shoe. Pull it directly across a nd insert it into the shoelace eyelet on the opposite side. Pull the shoelace through so the middle of the shoelace is center ed on the eyelets and the ends are even in length. 2 Place one end of the shoelace over the other so they are now crossed. Sk ip one set of eyelets to leave room for the other shoelace. Insert the shoelace diagonally across the shoe and into the eyele free 3d model lampshade t. Take the other shoelace and insert it into the eyelet on the opposite side. Repeat this step until the first shoelace has been inserted through every other set of eyelets up to the top of your shoe. 3 Insert the one end of the second shoelace thro diy casting bronze statues ugh the second set of eyelets. Run the second string underneath the cross made by the first two strings and directly through . eaning the row of eyelets closest to the tongue of the shoe. Lace as you would any other shoe but stop before you reach the t op eyelets. 2 Pull the first tongue out and flip it down so it's laying flat against the laces. Finish lacing the last two ho les of the inside eyelets. 3 Lace up the shoe with a new shoestring and use the outside eyelets. Lift the tongue up so you la ce under it. Lay it flat against the laces to lace the last of the outside eyelets. 4 Put the Converse double-upper low tops mircrosoft word fonts on your feet and adjust the laces so they're comfortable. Tuck the excess shoelaces laced through the inside eyelets into the shoe so they don't show. 5 Tie your Converse double-upper low tops with the laces threaded through the outside eyelets.1 Div diy casting bronze statues ide the microbraids into six sections and braid each one into a large loose braid. Secure the ends with a fabric-covered elas . under the showerhead with warm water and a medium water flow until the shampoo is washed away. Avoid rubbing the braids, whi ch could cause them to fall out or otherwise damage your hair. 5 Gently wrap your head in a large towel that is the same colo r as your hair since "fuzzies" from the towel might stick to the braids. Leave the towel on for at least 20 minutes. 6 Remove the fabric-covered elastic bands and gently unbraid the large braids. 7 Shake your head gently to return the braids to their nautilus desktop icons proper positions and smooth them down with your hands to flatten. 8 Spray a leave-in conditioner on your microbraids to cond ition. Allow to air dry.1 Wash your hair with shampoo and blow-dry it completely straight. Straight hair is a lot easier to w diy casting bronze statues ork with and a lot less unruly than curly hair. 2 Part a small piece of hair into a tiny section so that the area around it o .
|
|