cuttlebone casting bronzese natural human hair extensions if you plan on styling your hair with heat. Set the extensions next to your work area. 5 Sep arate your hair by running your comb along your scalp, from ear to ear. Pin the top portion of the hair out of your way using a clip. You will be beginning on the lower portion of your head, moving up and forward. 6 Comb the free hair until it is smo oth. Use the tip of the comb to separate a small, 1/4-inch section of hair from the edge of your hairline. 7 Separate the sma photoshop textures deviant ll section of hair into three equal pieces. Braid these three pieces by crossing the left section into the middle, over the c enter piece, then the right section into the middle and so on. 8 Stop braiding your natural hair after you have completed abo cuttlebone casting bronze ut three plaits. Holding the end of the braid in one hand, select a 1/4-inch thick piece of extension hair with your other ha . in the center of the extension hair, grasping the end of the braid tightly. You will now have three strands: one half of the extension hair, your braid and the other half of the extension hair. 11 Braid the extension tightly into your natural braid, continuing where the natural braid left off. 12 Stop braiding when you have achieved the length you'd like. The braid can be just a few inches, leaving plenty of loose hair for styling, or you can braid the entire length of hair to the tip. 13 Grab free book virg about three strands of loose extension hair from your braid and wrap these around the end of the braid to create a loop. Pull the ends of the extension hair through the loop to create a knot. Pull the knot up toward the scalp to tighten. This will se cuttlebone casting bronze cure the micro braid in place. Repeat for extra stability. 14 Repeat Steps 6 to 14 for the entire section of hair. Continue b . gher. 2 Apply a light coat of petroleum jelly to your eyebrows, fingernails, toenails and cuticles. When you apply your self- tanner, the petroleum jelly helps prevent the tanner from soaking into these spots. 3 Apply the self-tanner in light coats in sections. Be sure your lighting is sufficiently bright so that you can see what you are doing. Start with your legs and work your way up the body, finishing with a light coat on your face. When applying self-tanner near the knees and elbows, rub a b Alli it vigorously to avoid an accumulation in those spots. Some people avoid application to their hands; others may opt for a lig ht coat on the tops of the hands. When doing your hands, be aware that you need to wash your palms in hot, soapy water to avo cuttlebone casting bronze id "orange palm syndrome," which is a dead giveaway of self-tanning. 4 Build your tan gradually. This method helps you avoid .
|
|