clay used for bronze castingce from the inside of the shoe to the outside. Lay the lace horizontally over the top of the shoe. Thread the lace into the t hird eyelet on the left side. Thread the lace from the outside of the shoe. 6 Repeat until you have threaded the lace through all available eyelets. Slip your foot into the shoe and pull both sides of the lace taught. Secure with a bow.1 Roll the pos ter board into a cone shape and tape with the duct tape.Trim the open area until the cone fits comfortably on your head.It sh eshop templates wordpress ouldbarely come over the forehead and tilt mostly toward the back.Slit the tape and unroll the poster board.This is your patt ern. 2 Use the pattern to cut out the buckram and the fabric.Add ?-inch all the way around the outside edge of the fabric bef clay used for bronze casting ore cutting out. 3 Lay the fabric wrong-side up and put the buckram on top.Run a bead of glue on the edge of the buckram, the . use the matching thread to whip-stitch the hat and secure it in place. 5 Bend the 16 gauge wire around your head just above w here you want the edge of the hennin to sit.Add a couple of inches of overlap and cut the wire.Use the duct tape to secure, t hen wrap all of it in the black velvet ribbon.Cut another piece of wire about 7 inches long and bend it in half into a U-shap e.Cover it with the black velvet ribbon as well.Attach this U-shaped wire inside the hat so it is centered over the forehead project budget template free and comes down about 1? inches using the glue and a few stitches. 6 Embellish the hennin as desired.Find the center of the ch iffon and drape it over the point of the hat and secure with pins.To wear, put the wire band on your head, put the hat on ove clay used for bronze casting r it and attach the hennin to it with pins.1 Press one end of the boot lace up through the underside of the bottom eyelet of . up through the bottom of that eyelet and pull it through. Take the opposite end and do the same. Maintain the same pattern o f laces, either right over left or left over right, as you lace. 3 Continue lacing up the boot until both ends hang free at t he top of the boot. 4 Ladder lace boots that can be laced tightly. Push the lace into the top-most eyelet on your boot, then pull it out through the bottom eyelet on the opposite side. Take the end that has come out the bottom and then cross directly 3d model free downloading over and push the end down through the eyelet on the opposite side. 5 Take the end of the lace and pull it diagonally up to the next eyelet and pull it through. Cross the boot horizontally again and push the lace in through the eyelet. It will feel clay used for bronze casting like you're lacing in a spiral; keep going until the two ends of the lace once again meet at the top of the boot.Construction .
|
|