casting bronze or forging ironthe unclipped portion of the hair. The first strip should be synthetic, middle strip should be natural hair, and the third st rip synthetic hair again. Place the third strip over the second strip of hair so that it overlaps, and put the first strip on top of the third strip. The second strip of hair will now be on the third section. Again, place the second strip (which is n ow in the third section) on the top of the middle strip and overlap the first strip over the top of the third strip. Repeat t photoshop textures brushes his braiding procedure until you reach the tips of the hair. 6 Dip the tip of the hair into the cup of boiling water so that the ends will seal. Repeat Step 5 until you finish braiding that particular section of the hair. After you have done one port casting bronze or forging iron ion, remove the hair clip of another portion and repeat Step 5. Repeat the braiding procedure until you've finished all porti . ld the ends together to make them even. Do the same with the right lace. 2 Insert the right end of the left lace into the lef t eyelet of the same first pair of eyelets. Insert the left end into the right eyelet of the same first pair of eyelets. Inse rt the right end of the lace into the eyelet that has the left end coming out of it. Move the right end up and insert it into the eyelet above it. Do the same with the left end so that there is a double layer, or two parallel laces going across from free book trailers eyelet to eyelet. Repeat this step for the right-side boot lace. 3 Continue lacing the boots in this pattern, lacing first th e left boot lace, then the right boot lace, until you have laced up all of the eyelets and there is a set of two parallel lac casting bronze or forging iron es going across each pair of eyelets. Cross the right end diagonally under the zipper insert. Move the right end up through t . oot when the zipper is shut. 5 Tie off the lace ends by tying them into a square knot on the outside of the boot. Trim the en ds down to 1/2 inch. Use a lighter to burn down the ends, place the flame onto the lace ends and melt them down to the knot.1 Examine the shoe's tags. Start with the "All-Star" tag, which should be found across the heal and/or tongue of the shoe. Als o, inspect the circular Converse logo found on the All-Star high-tops, as well as the "Converse" letters printed on the insid Eat Right for Your Type e of the shoe. On all labels, ensure the stitching or ink is clear, crisp and clean, rather than dull, faded or smudged. Also , while it may seem obvious, ensure the words are spelled correctly and that tags have the appropriate designs. For example, casting bronze or forging iron the high-top classic Converse will come with a circular screen print logo that includes the words "Converse All Star," a soli .
|
|