bronze sculpture casting tourthe sari blouse, which resembles a sports bra. 2 Grab the plain end of the sari--the end without intricate beading--and fold it back and forth. Create five or six equal pleats about 2 inches thick. Tuck the top of the pleats into the right front of y our petticoat. Make sure the bottom of the Saree touches the floor or meets your desired length. 3 Wrap the sari around your waist once from the plain end. Tuck it into your petticoat at the same place where you made the first tuck. Make sure the len free book themes gth is still brushing the floor. 4 Drop the plain end of the sari and grab the beaded end, also called the Pallu. Wrap it aro und you loosely one time. Begin folding it into pleats as you did with the plain end. Make sure the pleats are even, bunch th bronze sculpture casting tour em in your hand and drape the beaded endover your shoulder so it reaches to the back of your knees. You should now have a sec . ly folded, tuck the remaining loose fabric into the petticoat.1 Cut each end of the ribbon's length at a 45 degree angle to p revent fraying. Lay the ribbon out on a work surface and measure 57 inches from the left end of the ribbon and make a small m ark with your chalk or pencil. This will be just past the center point of the ribbon. From that mark, measure 33 inches furth er and mark again. The words and decorations for the sash will go between these two marks so that they can be seen when the s Fast Diet ash is worn. 2 Use a computer text editor to spell out the text you want on your sash. Experiment with fonts and text sizes t o get the look you want. Block letters are easiest to read, and a very elaborate Gothic or calligraphic font may be difficult bronze sculpture casting tour to cut into a stencil later. 3 Print out your text with the letters no less than 2 inches tall and no more than 2 1/2 inches . e the stencil. 4 Cut down the printer paper until your text is on strips 4 or 5 inches tall and trim off any extra white spac e on the ends of the words. Arrange the pieces of paper so the text looks the way you want it to look. Measure it again to ma ke sure it doesn't exceed the 33 inches of space available on the ribbon. 5 Use a thin film of white glue to mount the paper with your text on it to the cardstock or posterboard. Use the yardstick to keep the letters straight and evenly spaced. Let t free templates charity he glue dry thoroughly. 6 Cut out the letters with a craft knife to create a stencil. Remember to leave thin connecting strip s to hold together letters such as O and A which have enclosed spaces within their shape. 7 Lay out the ribbon for the sash o bronze sculpture casting tour n a work surface and use masking tape to hold it steady and flat. It is very important that the ribbon be laid out so that th .
|
|