the bronze casting processh the nape of the neck. Once you get to the nape of neck, continue to plait the loose hair to the tip and secure with a small hair rubber band to secure the braid. Completing the Style 14 Remove the hair clamp from one side of the hair, and make the third part parallel to the second part as described in Section 1. 15 Complete the second cornrow braid as described in Sectio n 2. 16 Repeat the steps in Sections 1 and 2 to complete the first half of the head, and then move on to the second half unti i cannot see my desktop icons or start menu l the whole head is completed. 17 Wrap with a silk hair scarf at night to protect your style while sleeping.1 Push one end of the lace through the lower left eyelet,so the loose end is inside the shoe, then push the other end of the lace through the the bronze casting process lower right eyelet. 2 Pull the right-side loose end through the second-lowest right eyelet, so the loose end hangs outside th . g loose end through the next available left eyelet after the eyelet through which you pulled the other loose end. 5 Cross bot h loose ends over the tongue ten through the matching eyelet on the right so the laces are in the shoe again. 6 Continue thre ading the laces in pairs until you have tucked them through the top two rows of eyelets. 7 Tie a knot with the two loose ends . As the lace ends are inside the shoe, your knot will be hidden from view.1 Disconnect all power sources from the shaver. Re business proposal plan template free move the shaver from the stand if it is in the stand and unplug it if it is plugged in. 2 Remove the shaver foil. Press the f oil release buttons on both sides of the foil and lift it away from the shaver. 3 Tap the foil on a flat surface. 4 Clean the the bronze casting process cutter block where you removed the foil from the shaver by brushing lightly with the cleaning brush. 5 Clean the inner area . il it clicks into place.1 Comb your hair using a wide-tooth comb. Using the comb, divide your hair into three even sections. Comb each section so there are no tangles and it lays as flat as possible. 2 Use your right hand to grasp the section on the right and cross it over the middle section. Hold both the right and middle sections with your left hand, but make sure they s tay separate sections. The right hand section should now be the middle section. Pull it as tight as you can and cross the lef free pat testing certificate template t hand section over the middle section so the left hand section becomes the middle section. 3 Pull your hair tight and cross the right hand section over the middle section again. Tighten the braid. Then alternate the left and right, making sure to ti the bronze casting process ghten after each weave. Continue until you reach an inch or two above the bottom of your hair. 4 Pull your hair as tight as y .
|
|