bronze casting with waxpart into two, one on the right and one on the left. Hold the right piece of hair in your right hand, the left piece in your left hand. 6 Wrap the right section of hair over the left section using your index fingers and thumbs, and then wrap the lef t section over the right making a twist. 7 Add more hair from the section into the right piece, then wrap it over the left si de again. Add more hair to the left piece and wrap it around again. Repeat this action as you twist the entire section of hai access web templates r together. 8 Secure the end of the twist with a bobby pin by inserting it at the end of the twist inward so the bobby pin is inside the twist and invisible. 9 Repeat steps four through eight with each section of hair until you're done.How To Shave U bronze casting with wax sing a Mug and Brush 1 Wash your face with hot, soapy water to help condition the skin and open the pores to expand the facia . water. Remove the brush from the water and shake out excess water. Pour the water from the mug. 4 Brush the bristles of the shaving brush rapidly across the shaving soap in a circular motion to produce a rich, foamy lather. Brush the lather onto the portions of your face that need to be shaved. 5 Rinse the shaving edge of your razor with hot water. Shave by drawing the ra zor over the desired area with the grain (in the direction of hair growth) until all unwanted hair is removed. Rinse the razo budget template free download r blade frequently to remove soap and stubble. 6 Reapply soap using the shaving brush. Shave by drawing the razor over the de sired area against the grain, or the direction of hair growth, to obtain an even closer shave. 7 Rinse the razor and put it a bronze casting with wax way. Rinse your face off with hot water and pat dry with a towel. Apply after shave lotion if desired. 8 Rinse the shaving br . attern, placing bodice's front along the fold and its back on along the fabric's edge. The sleeve pattern should also be plac ed along this edge. Then, pin the patterns down and then cut them out with a pair of fabric sheers. 2 Trace the front and bac k bodice's darts (triangular pleats) from the pattern onto the fabric. Starting with the front of the blouse, place a sheet o f tracing paper between the pattern and fabric. Then, place another sheet on the table and lay the fabric on top. While press 3d model freeware ing hard, go over the lines on the pattern with a tracing wheel, to ensure that the dart's lines duplicate on both sides. Rep eat the process to the back bodice. 3 Pin the triangular folds (darts) together on the front and back bodices, before stitchi bronze casting with wax ng the darts with a sewing machine. These darts should help to give the bodice a more form fitting shape. 4 Start constructin .
|
|