bronze casting santa feratio. If you have one ounce of bleach, you will need nine ounces of water. In another bottle, mix the soap and the water in an 2:8 ratio, meaning that if you have two ounces of liquid soap then you will need eight ounces of water. Fill the last spra y bottle with water. Once you have the lids on tightly, then you can shake all of these bottles gently to mix the solutions. 3 Clean the tanning bed with the soap and water solution. There may be a bit of foaming on the bed when you spray the solutio command line fonts n. Wipe the bed down thoroughly once you have sprayed it with the solution. Make sure that you get every corner. By the time you are done, your cloth will be damp and your bed should be nearly if not totally dry. 4 Spray the bed down with the bleach bronze casting santa fe and water solution. This will remove any bacteria that the soap and water did not kill. Make sure that you get every corner, . dry if not fully dry. 5 Rinse the bed with the clean water. This will remove any soap or bleach residue that might irritate s kin when someone next uses the bed. If you like, let the water sit for about 20 seconds before wiping down the bed for the la st time. Make sure that the bed is dry when you are done wiping it with your third cloth, even if you have to run the cloth o ver it several times.1 Part the hair. The hair should be parted into sections. Start from the rear of the scalp, go up an hal windows icon viewer f inch to an inch, and part the hair horizontally across the scalp. 2 Pin up the excess hair above the part to move it out of the way. 3 Separate a small section of hair in the row you just created with a vertical part. This section will be your firs bronze casting santa fe t braid. 4 Brush or comb the section of hair thoroughly. 5 Pin up any excess hair from the row to move it out of your way. 6 . s of the extension portion should be hanging to the left and right of the finger. If not, adjust it so it is being held in th e middle of the strand. 8 Divide either the left or the right side of the extension into two separate parts. Your extension s hould be divided into three individual strands now. One on one side, and two hanging on the other side ofyour finger. You can rub gel along the extension strands to prevent fly-aways. 9 Place the middle of the extension portion directly in front of t clothing photoshop textures he root of the real hair section. Add the natural hair section to the middle section of the extension portion. The two strand s will both become the middle strand for braiding purposes. 10 Wrap the left and right sides of the extension portion around bronze casting santa fe the middle hair strand made up of both the natural and extension hair. 11 Begin to braid the hair. Use the the left and right .
|
|